HiPer HR | TOPCON Positioning Web Site

HiPer HR FAQs

Question: What is the calibration procedure for HiPer HR?
Answer: Displays the observation screen (circular bubbles are displayed at the bottom of the screen). Calibration is required when the big remark is displayed, when the site area or the environment changes. (1) Enter "Machine installation", "TILT", "Calibration" from "M mark" in the upper left. * Calibration is performed in a place with a satellite reception environment. (2) Install the main unit and install it, press "Calibration" in "Level" so that it does not move until the calibration is completed. (3) Press "Compass (3D)" and "Calibration" and repeat this until the gauge at the bottom of the screen is completed, "turn it 45 degrees in the horizontal direction after turning in the vertical direction." ④ Press "Compass (horizontal)" and "Calibration" and rotate repeatedly until the gauge at the bottom of the screen is completed in the horizontal direction. That is all.
Order: 001

Question: Two of the antenna heights are displayed as L1 and L2, what does it mean?
Answer: L1 is first frequency and L2 is second frequency
Order: 004

Question: What are the specifications of the internal and external batteries?
Answer: When observing, use it in the order of external batteries → internal batteries. Only the internal battery is used during storage.
Order: 005

Question: The wireless antenna is on the GNSS reception antenna, does satellite reception affect?
Answer: The wireless antenna of HR and GR-5 is attached to the center of the GNSS receiver, but is designed so that it will not affect it.
Order: 006

Question: What is the model number of the charger for the HiPer HR unit?
Answer: The following three items are required to charge the HiPer HR itself. ① Power cable (ODU-SAE) with ferrite core ② AC adapter (12V5A) ③ AC cable (for adapter 12V5A)
Order: 007