OSseries-001
- Question
-
Is it possible to switch clockwise/counterclockwise with the OS?
- Answer
-
Setting 7. Customization 1. Observation 3. You can change the assignment with a soft key. It is R/L. It can be switched with the assigned R/L.
- Order
-
001
OSseries-002
- Question
-
What is the procedure to enter single-byte capital letters on the numeric keypad?
- Answer
-
Switch characters with the [α] key, press and hold the [Shift] key to switch lowercase and uppercase letters.
- Order
-
002
OSseries-003
- Question
-
The password was not set, but the screen came out.
- Answer
-
The device cannot be used until the correct password is entered, which requires that the instrument be sent out to purchasing company if it is to be unlocked.
- Order
-
003
OSseries-004
- Question
-
It does not work during the program execution.
- Answer
-
Turn the power off, hold down the enter key, turn the power on, and restart.
- Order
-
004
OSseries-005
- Question
-
Distance resolution: Is there a 0.1mm setting? (OS series)
- Answer
-
It is not adopted in the OS series. It is used in PS, DS, and GT.
- Order
-
005
OSseries-007
- Question
-
Can the battery BDC72 be used in the OS series instead of BDC70?
- Answer
-
Can be used.
The charger for BDC72 is CDC77.
- Order
-
007
OSseries-008
- Question
-
Why does the OS series shift about 1' when measuring just above zenith?
- Answer
-
Near the zenith and directly below, the tilt correction is cut off, so the tilt of the instrument will appear as it is. Align the center with the electronic bubble tube on the screen.
- Order
-
008
