BuildTech
Topcon Building Construction Solution Center in Tokyo
Promoting DX in construction industry to be the first case in the country*
To experience our digital measurement solution is our concept.
"BuildTech" was established on the premises of Topcon Corporation's headquarters to provide visitors with hands-on experience of construction DX(Digital Transformation) solution by creating a demo space as it is on an actual construction site.
The indoor space as a whole reproduces a wide range of construction site conditions, including interior and exterior, and allows visitors to experience 3D digital measurement at each basic step of the construction process of marking (positioning), installation, and inspection.
Visitors can systematically learn and understand Topcon's building construction solutions, including the linkage of measured data with BIM data and how it can be used at construction site. In addition, this whole space can be used as an innovation lab for building construction.
* Based on our own research as of August, 2021
Contents
"BuildTech" in video
Experience digital measurement for real
BuildTech has a full lineup of measuring instruments and various equipment to provide a realistic experience of measuring actual building components and models with actual equipment.
You can learn about digital measurement methods through hands-on experience, and we encourage you to solve your own problems.
14 different demonstration programs are available, and more to come
BuildTech offers demonstrations and measurement experiences that provide a hands-on understanding of 14 different solutions.
You can learn about a variety of measurements in a comprehensive manner or delve into a single measurement to understand and master it.
It can also be used as a discussion forum for the creation of new measurement methods, hardware, and software.
1. Layout work using LN and BIM/CAD design data.
2. Installation of batter boards for foundation using LN.
3. Layout work and inspection of piles using LN and BIM/CAD data.
4. Verification of foundation using BIM model.
5. Verification of anchor bolts position using LN.
6. Overlay comparison of CAD drawings and scanned data.
7. Real-time verification of steel columns plumbness using LN.
8. Comparison of BIM model and scan data for columns and beams.
9. Evaluation of concrete floor flatness using scan data and software.
10. Evaluation of concrete slopes gradient using scan data and software.
11. Navigation of MEP layout markings using LN.
12. Creation of BIM model of Plumbing and structural members from scan data.
13. Verification of interior wall placement.
14. Verification of insulation thickness using scan data.
Virtual demonstration is also available
BuildTech has cameras and mixers available for streaming.
We can remotely demonstrate instruments or hold any sessions with a distant location or for multiple locations at the same time.
Demonstration menus can be selected from 14 programs shown above.
For those who wish to visit
Location of BuildTech
It is located at Topcon Corporation Head Quarter in Tokyo.
Address:
75-1, Hasunuma-cho, Itabashi-ku, Tokyo 174-8580, Japan
Subway:
Approx. 10 minutes walk from Exit A-2 of “Moto-hasunuma” station on the Toei Mita Line
Train:
From “Akabane” station West Exit on the JR Line,
approx. 10 minutes by Kokusai-kogyo bus (220 yen)
for “Tokiwa-Dai station” (Route No.53) (see MAP-2)Approx.
1 minutes walk get off
at “Akabane-nishi 6-chome” bus stop
Taxi:
Approx. 10 minutes by Taxi (730 yen to 910 yen)
Contact
Any inquiries or reservations for visit, please contact us from below.
Frequently asked questions
Please check the BuildTech-FAQ by clicking the button below.
